Posted by C. Wayne Moore on 12/3/09 9:41am
Msg #312935

Brother 5250DN Problems

Replaced the cartridge with a generic and cannot get toner light to reset. Any suggestions?

Reply by Terrie Sliger on 12/3/09 9:56am
Msg #312940

did you shut printer off and turn back on? May have to reboot computer.

Reply by C. Wayne Moore on 12/3/09 11:29am
Msg #312956

Turned printer off and on! Still no success!

Reply by Regal/NC on 12/3/09 12:06pm
Msg #312961

Place tape over chip on cartridge.

If cartridge has a chip attached, just place strip of tape across.

Reply by C. Wayne Moore on 12/3/09 12:53pm
Msg #312973

Got it cleared! Thanks everyone! n/m

Reply by jba/fl on 12/3/09 12:55pm
Msg #312975

Now you need to share how? n/m

Reply by C. Wayne Moore on 12/3/09 1:03pm
Msg #312978

How to reset!

OK!

1. Turn the printer off
2. Open front cover
3. Hold down "Go" button and turn printer on
4. When all led lights are solid release and then press "Go" twice.
5. Close front cover and it should be reset.
6. Press "go" five times to print test page.

I believe this is correct but it has been longer than 30 minutes since I did it so no promises.

Reply by jba/fl on 12/3/09 1:16pm
Msg #312981

Close enough - TY n/m