Posted by Susan Fischer on 10/2/09 8:36pm
Msg #305980

Stupid question - Have the Stingray. Found the bottle of

ink to refill. So far so good.

Humm. So, how does the ink get in? Tried orange button - nada.

Tia.

Reply by Vince/KS on 10/2/09 8:43pm
Msg #305981

Gently pull the colored top from the main body - then

follow the directions printed on the side for number of drops to use per tube - then wait two to three hours before use. Do not over ink.

Reply by Susan Fischer on 10/2/09 9:05pm
Msg #305984

Ok. Top off - that was easy. No directions anywhere.

The only thing printed on the little bottle are warnings not to drink the ink, nothing on the stamp.

Whaddya think? 3 drops?

Reply by Susan Fischer on 10/2/09 9:08pm
Msg #305985

And, thanks, Vince. I'm always afraid to pull too hard on

things, mostly they tend to go -SPROINGGG-

Reply by MW/VA on 10/2/09 9:28pm
Msg #305991

Re: And, thanks, Vince. I'm always afraid to pull too hard on

ROFLMAO --You really didn't say this, did you, Susan?

Reply by Vince/KS on 10/2/09 9:12pm
Msg #305988

says Stingray 5 and 6 get 8 - 12 drops per tube

Stingray 10 & 12 get 15 - 20 drops per tube. And do not over ink.

Actually says wait 2 to 3 hours to make sure any ink is needed after use. Ink then wait a total of 3 hours after re-inking for normal use.

Reply by Susan Fischer on 10/2/09 9:15pm
Msg #305989

Okey Dokey. Tanks. I pushed the two on each side of the

middle thingie, and now it's stuck 'down' . I knew it - sproing!

Reply by Susan Fischer on 10/2/09 9:24pm
Msg #305990

I de-sproinged. Dropping now. If all problems could be

solved so easily.

Appreciate your techie advice, thanks again.